I added spectrum analyzers to each Mixer track to visually show what’s going on here. The heavy presence of the bass synth in the 60 Hz to 125 Hz range is drowning out the kick, which should one of the most prominent instruments in the track. Here’s what it sounds like without sidechain compresison applied: I set a basic pattern for the kick and a few simple chords for the Swagger Bass synth I made in Sytrus and overlapped them in the Playlist. This uses the compressor setting in the Fruity Limiter plugin to compress the bass signal when the kick is triggered. With the first technique, we’ll use Fruity Limiter to sidechain a kick to a bass saw synth.

Infographic by: Sidechain Compression in FL Studio Using Fruity Limiter Get a look at this handy infographic for a quick run down. This article will outline three different ways to get it done. Sidechaining in FL Studio can be done a few ways depending on what you want your end result to sound like and how much control you want over the sound. The bass volume “ducks” under the kick when the kick is triggered, and this effect makes the low end of the kick more present. The kick signal is used to control the presence of the bass in the mix so the two are not competing against each other in the bass regime of the frequency spectrum (40 Hz to 250 Hz). In electronic music like trance, house, and techno, we usually do it with the kick and the bass. Sidechaining is a signal processing technique where we use the amplitude (volume) of one signal waveform to control some parameter of another signal. In this tutorial, you’ll learn how to sidechain in FL Studio.

Step 1: Add and Create a Fruity Balance Volume Automation Clip.

How to Sidechain in FL Studio Using Automation Clips.

How to Sidechain in FL Studio Using Fruity Peak Controller.

Step 2: Fruity Limiter Compressor Settings.

Sidechain Compression in FL Studio Using Fruity Limiter.

Send channels fl studio 12